
Structure & Features
1. Fixed length total assembly with L = 1040mm, factory dynamic balance correction, low vibration during high-speed operation;
2. Dual universal joint structure, compensating for the angle caused by up and down movement and frame deformation;
3. Extension spline pair, absorbing the axial length change generated by suspension compression / extension;
4. Overall welding + flange connection, matching the original factory installation holes, direct replacement, no need to modify the bracket;
5. Cross shaft with oil nozzle, supporting regular grease lubrication to extend service life;
6. Heavy-duty calibration, suitable for dump trucks, trailer standard load / heavy load working conditions.
The original transmission shaft has excessive clearance, the cross shaft is loose, there are abnormal noises, and there is a "clunking" impact during starting.
✅ The dynamic balance of the transmission shaft has failed, causing the vehicle body and chassis to shake when the speed increases.
✅ The spline is worn, the dust cover is damaged, and oil leakage and water ingress occur.
✅ The transmission shaft is distorted, cracked, deformed, or broken.
✅ After replacement: The power is transmitted smoothly again, the impact during starting is eliminated, the shaking during driving is reduced, and the periodic abnormal noises from the chassis are eliminated. It also avoids power interruption and damaging the differential / gearbox rear end.

FAQ
Q: What is the function of this drive shaft?
A: It transmits engine torque from the gearbox to the rear drive axle. The universal joints and sliding spline compensate for angular deflection and axial length change caused by suspension movement and chassis deformation while driving.
Q: Which truck models fit DZ9114315104?
A: It is designed for Shacman Delong F2000, F3000 and M3000 heavy trucks. Overall length: 1040 mm. Please confirm the original OE number and mounting flange before ordering.
Q: What materials are used?
A: Shaft tube: 40Cr seamless alloy steel pipe
• Yoke & flange: forged 40Cr, quenched & tempered
• Cross spider: 20CrMnTi, carburizing hardened
• Spline: 40Cr with surface hardening
• Boot & seal: oil-resistant NBR rubber
Q: What symptoms indicate that the drive shaft needs replacement?
A: Clunking noise on acceleration / deceleration, obvious chassis vibration at medium-high speed, loose universal joint, oil leakage, cracked boot, twisted or cracked shaft tube. Continuing to run with a failed shaft may damage the gearbox or rear axle.



Hot Tags: transmission shaft assembly dz9114315104, China transmission shaft assembly dz9114315104 manufacturers, suppliers, factory, Automotive Air Conditioning Condenser, Front Left Engine Bracket DZ9112590185, QH70C G646 , REAR ENGINE MOUNT DZ97259590209, Truck AC Pipe Hose Assembly, Truck Engine Brake Compressor
