RIGHT FRONT COMBINATION LIGHT W23604.45200.02W-D

The function of the right headlight is to illuminate and expand the visible field of vision. The functions of car lights generally have two types: 1. Illumination at night or in poor lighting conditions, such as high beam and low beam lights; 2. Warning and reminder, such as turn signal lights and hazard warning lights.

For motor vehicles with a four-lamp system, if two symmetrical lamps meet the requirements of a two-lamp system, they are considered qualified. For TOP, the beam irradiation position of the headlight is detected using a screen. A dedicated screen is set up 10 meters away from the headlight. According to the specified inspection conditions as mentioned above, three vertical lines and three horizontal lines are drawn on the screen. The middle vertical line V-V is aligned with the longitudinal center line of the inspected vehicle. The vertical lines on both sides V-left-V-left and V-right-V-right are the center lines of the left and right headlamps of the inspected vehicle; the horizontal line h-h is at the same height as the center of the headlight of the inspected vehicle, with a height of H (mm) from the ground; the height of the next horizontal line is H1, which is at the same height as the upper limit value of the far beam light center of the inspected vehicle (0.9H), and the height of the bottom horizontal line is H2, which is at the same height as the upper limit value of the near beam light center of the inspected vehicle (0.8H). The standard stipulates that the deviation range of the center height of the high and low beam lights is 0.05H and 0.2H respectively, that is, the lower limit values are 0.85H and 0.6H.

Tail light bulb classification: Currently, there are mainly three types of tail light bulbs: one is halogen car bulbs, one is HID car bulbs, and the other is the emerging LED car bulbs. Nowadays, most of them are using bulbs made of LED materials. This is because LED materials have advantages such as being environmentally friendly, energy-saving, highly efficient, long-lasting, and capable of changing the color of light.

The working principle of LED lights: LED is actually composed of several compounds and is a type of semiconductor. However, its main core component is a semiconductor chip attached to the base of the LED light, while the other end is connected to the power supply. After being properly connected, it is encapsulated. When an electric current passes through this device, photons will be generated and energy will be emitted. This is the working principle of LED lights.

LED lights are different from traditional lamps. LED lights use high-power LEDs and are made with heat-conducting materials that have good heat dissipation properties. This is much better than traditional lamps.

The car combination switch usually has the lights on the right side. Turning one knob moves it to the near light position, and turning two knobs moves it to the far light position. In the original state, raising it up is the instant far light. If the switch is on the automatic gear, when there is insufficient light (such as at night, passing through a tunnel, entering a garage, or in rainy weather, etc.), to ensure driving safety, the sensor located on the inner side of the front windshield and above the dashboard will automatically turn on the headlights. When the light is sufficient, it will automatically turn off. Therefore, when the automatic lights are needed, you can put the car in automatic gear to enjoy this function. Keeping it in automatic gear for a long time is also fine, and it has no effect on the vehicle. When starting the vehicle in insufficient light conditions, since it is in the AUTO gear position, as long as the key is turned to the power-on position, the headlights will light up. At this time, starting the engine will increase the starting load. Therefore, it is recommended to set the lights to the OFF position when starting the vehicle in insufficient light conditions. After the vehicle starts, you can then switch to ON or AUTO gear. The car's headlight combination switch: If there is an increase in the starting load, pay attention to manually adjusting the switch to avoid keeping it in the AUTO gear for a long time.